Step 1: Sanding. Sanding uses abrasive paper to remove the glossy top layer of paint. This will dull the finish and give it a more matte appearance. You’ll need to start with coarse sandpaper and move up to finer grits as you go. The goal is to remove the glossy top layer without damaging the underlying paint job. Be especially careful not to saturate the wood here. The benefit you get from using soap is that the acetone helps break down the residue. 5. Wipe Off the Soap Residue. You can use a clean damp cloth to wipe off the soap residue here. This will help you remove loose acetone and soap from the wood surface. 6. In the other bowl, mix a half-cup of baking soda with a tablespoon of vinegar. Then dump the mix in bowl two into the mix in bowl one and stir with a wooden stick for 5-10 minutes. 3. Apply. Once your mix is ready, grab a paint brush and start applying the mix to the polyurethane. To use this low VOC chemical stripper, simply apply it to the piece of furniture or wood surfaces you wish to strip, allow it to absorb into the existing finish for about 20 minutes to 2 hours to soften and loosen paint up, then wipe it away or scrape it off with a plastic scraper when you see the paint bubble. Step One: First, apply the chemical stripper to the wood surface with the paintbrush. Make sure to cover the entire surface evenly. Step Two: Next, let the stripper sit for about 15 minutes. Step Three: After 15 minutes, use the rag to wipe off the stripper and the shellac. Home Depot makes a Ready Strip deglosser. Cuts the gloss of paint helping to insure proper adhesion for new coatings. Works on most surfaces including wood, plaster, metal, masonry, concrete and fiberglass. Water-based formula is ideal for use indoors and outdoors. Non-corrosive to prevent damage to wood, metal, stone, fiberglass and floors. Step 1: Setup and Clean the Surface. Wipe down the surface of the wood that you will be removing the polyurethane from. Let it dry completely before moving onto the next step. While it is drying, set up your workspace. Lay down a drop cloth to catch any spills and set up fans to help with the fumes. Step 2: Apply The Citristrip Paint Stripper. Next, you apply the Citristrip to your project. You will want to use an old paintbrush that you won’t mind throwing away. A super cheap synthetic brush or chip brush will work well. The brush will get really gunky so you’ll want to toss it afterwards. Vay Tiền Nhanh Ggads.

how to remove finish from wood